GeneChip Array Library Files

Instructions

WinZip is required for accessing the files. Download and install a free evaluation version of WinZip, then download the zipped files to your hard drive using the links below. Double click on the downloaded file to open WinZip and begin the installation.

For large files, you may wish to use a free download manager. Simply download the program and double click on the file you wish to access. The manager will allow you to speed up, schedule, and pause/resume any downloads from the site.

GeneAtlas array strips

Array strip library files are for use with the GeneAtlas™ system and GeneAtlas Instrument Control Software. If you have an internet connection from the GeneAtlas instrument control computer workstation you can automatically download and install these files by following the instructions for installing library files in the GeneAtlas User's Guide. If you do not have access to the internet from the instrument control workstation download the library file *.zip file of interest, copy it to the instrument control workstation and extract the contents of the *.zip file to C:\Command_Console\Library.

GeneTitan and GeneTitan HT Microarray System and AGCC 3.x software

The following array plate library files are intended for use with AGCC 3.x and higher for use with the GeneTitan™ family of instruments. Please note that the library files in this section cannot be used with AGCC 2.x. To find out which version of AGCC version is installed on your system, visit the AGCC Portal web page and observe the version number in the Help > About page.

Download the zip file and save the file to a folder on the workstation. Start the GeneTitan library file installer from the AGCC launcher window and set the source path in the application to the folder containing the array plate zip files. Start the install. Please note that the data files in the zip should not be extracted or uncompressed. The zip file must be saved as is with the .zip extension. Please refer to the AGCC user manual for additional information.

• AGCC 3.x HT HG-U133A Library Files (zip, 12 MB)
• AGCC 3.x HT HG-U133B Library Files (zip, 12 MB)
• AGCC 3.x HT HG-U133PM Plus and HG-U133 Array Strip Library Files (zip, 13.9 MB)
• AGCC 3.x HT MG-430 PM Array Plate and Array Strip Library File (zip, 12 MB)
• AGCC 3.x HT MG-430A Library Files (zip, 12 MB)
• AGCC 3.x HT MG-430B Library Files (zip, 11 MB)
• AGCC 3.x HT Rat-Focus Library Files (zip, 11.9 MB)
• AGCC 3.x HuGene-1_1-ST-V1 Library Files (zip, 194 KB)
• AGCC 3.x MoGene-1_1-ST-V1 Library Files (zip, 338 KB)
• AGCC 3.x RaGene-1_1-ST-V1 Library Files (zip, 448 KB)
  
  

GeneChip array cartridges

WinZip is required for accessing the files. Download the zipped files to your hard drive using the links below. Double click on the downloaded file to open WinZip, extract the files, and begin the installation.

Array library and analysis files

WinZip is required for accessing the files. Download the zipped files to your hard drive using the links below. Double click on the downloaded file to open WinZip, extract the files, and begin the installation.