Having difficulties with your experiment?

We are dedicated to your success. Get back on track. View our expert recommendations for commonly encountered problem scenarios.

View the relevant questions below:

Beginning your experiment? 
Visit our:

Getting Started page

Gene expression

ハイブリダイゼーション時間が 16 時間を超えて延長されるとどうなりますか？

The standard gene expression hybridization time is 14-16 hours at 45°C. At high temperatures and longer incubation times the sample will evaporate. Loss of sample is undesirable for several reasons:

  • Low volume of hybridization solution in the probe array can lead to dry spots that will show up as uneven hybridization and thus, compromise data.
  • Sample loss compromises the possibility of repeating the experiment with the identical sample.
  • Sample evaporation can lead to changes in the salt concentration of the solution which can affect the stringency conditions for hybridization.
複数の _at プローブセットが同じ遺伝子にマップされているにもかかわらず、発現結果が異なることが時々あります。 この違いはどのように考えればよいですか？

There are various reasons why this happens. With increasing knowledge of the genome, the unique probe sets (_at probe sets) that were initially designed may turn out to represent subclusters that have collapsed into a single cluster in a later design. Therefore, it may seem that multiple "unique" _at probe sets now correspond to a single gene. Different results from the probe sets could be observed due to the following reasons:

  • They represent splice variants or may cross-hybridize to different members that belong to a highly similar gene family or transcripts with different poly-A sites.
  • One probe set is more 5' than the other.
  • One probe set is better designed than the other.

In these cases, it is important to use the resources available on the NetAffx™ Analysis Center to understand if any of the above scenarios apply. Other expression analysis techniques may also be used to confirm which probe set reflects the transcript level more accurately.

異なる施設や異なる時期に得られた結果を、互いに直接比較することはできますか？この種の実験では、どのように変数をコントロールすればよいですか？

Array results can potentially be compared directly. However, it is important to check the following important elements before doing so:

  • Experimental design strategy should be the same at various sites.
  • Identical target labeling protocols should be followed, and yields from cDNA and IVT reactions should be within the same range as specified for that study.
  • Same algorithm parameters are used.
  • Similar results from 3'/5' ratios, background, noise, and scaling factors. Check arrays for scratches and even hybridization/staining.
  • Comparability of results obtained from different operators should be evaluated before including their results in the same study.

For Research Use Only. Not for use in diagnostic procedures.