Find valuable information.

Optimize your experiments to get the best results. We’ve compiled a detailed knowledgebase of the top tips and tricks to meet your research needs.

View the relevant questions below:

Beginning your experiment?
Visit our

Getting started page

General
プローブの標識色素が不明である場合の対象方法。

You can check the paperwork that came with your order for the dye label of your probe. Alternatively you can contact Customer Service at genomicorders@lifetech.com with your order number if you cannot find the COA that came with your probe.

カスタムプローブが機能していない その場合の対処方法。

There are several reasons why a custom probe may not be working. If the probe sequence is new and has not been tested before, please check for the following:

  • Run the probe with a positive control to check for amplification.
  • Were different concentrations of probe tested?
  • Is there any product visible on an agarose gel?
  • How was the probe designed? Was it checked for specificity for the relevant species?
  • Check that the probe reporter dye has been set correctly in the software.

If the probe sequence has been used successfully in the past, please check for the following:

  • Run the probe with a positive control to check for amplification.
  • Run a side-by-side test on the same plate with probe from a previous lot to rule out problems from sample or master mix.
  • Check that the probe reporter dye has been set correctly in the software.

If you suspect a problem with your custom probe, please send your data and order information to techsupport@lifetech.com so that we can review the issue further.

カスタムプライマーまたはプローブの配列を確認する方法。

Sequence information would be provided on the COA or CD that arrived with the order. If you have lost the CD, you can contact techsupport@lifetech.com with your order number for sequence information.

Need more information? Contact us ›

For Research Use Only. Not for use in diagnostic procedures.